|
Competition TJ Stinger Hoop.
Forward lean of 12-13 inches.
Custom built front bumper brush guard for a Jeep Wrangler TJ. This hoops is tall and lean. It looks like a competition Buggy Stinger.
Custom Welded Hoop brand new.
Fit a stock bumper with after market tow hooks.
Details:
This Grille Guard is tall and strong on the front of your Jeep Wrangler.
Adds great looks and protection to your Jeep Wrangler TJ.
Bolts right to your Factory Bumper / Tow hook mounts.
The Hoop is made from 1.75 inch(diameter) DOM .120 wall tube. This is the same tube used to build roll cages, race cars and custom tube buggies.
The hoop is MIG welded to 3/16 plates that sit flat on your bumper.
The plate is profesionally stamped the holes punched out to match your f
actory bumper holes exactly. These holes are 5/8 inch x 3/4 inch so there is a little bit of play for easy installation.
Gloss Black Paint, also available in unpainted or dark gray primer if you want to customize the color.
Strong sturdy design to take punishment and still look good.
The bolts are 30.75 inches wide at the bottom. The Hoop is about 8
inches wide at the top of the hoop and about 24 inches tall. As you can see it is about top of your Jeeps hood.
Fits Jeep Wrangler TJ and Rubicon 1997 - 2006.
Installation:
Installation is easy. Remove the top bumper bolts, set
the hoop on the top of the bumper and replace them. These bolts are a Torx
55 bolt head. This tool is available at any parts store. I got a Torx 55
at Autozone because of the lifetime warranty. The old bumper bolts can be tough to remove,
in some cases plan on using a big breaker bar, with a cheater pipe over the handle.
I also recommend that you get a good set of 10,000 lbs tow hooks
(From my online store) and put them on at the same time. Place the hoop on top of the factory bumper, and then the tow hooks. Then put the bolts in,
make sure to only put them in loosely and get all 4 of them started and
turned 1-3 turns before tightening any of them down. If you have bumped
or bent your bumper at all this process maybe a bit tricky. But it should not be any problem. I make the mounting holes in the hoop plates a bigger and oblong so it will easily fit.
|
