TJ Leaner Hoop for use with after market tow hooks.
Forward lean of 3-4 inches.
Custom built front bumper brush guard for a Jeep Wrangler TJ. These are brand new custom made welded hoops.
This Grille Guard stands tall and strong on the front of your Jeep Wrangler.
Adds great looks and protection to your Jeep Wrangler TJ.
Bolts right to your Factory Bumper / Tow hook mounts.
The Hoop is made from 1.75 inch(diameter) DOM .120 wall tube. This is the same tube used to build roll cages, race cars and custom tube buggies.
The hoop is MIG welded to 3/16 plates that sit flat on your bumper.
The plate is professionally stamped the holes punched out to match your factory bumper holes exactly.
Gloss Black Paint, also available in unpainted or dark gray primer if you want to customize the color.
Strong sturdy design to take punishment and still look good.
The bolts are 30.75 inches wide at the bottom. The Hoop is about 14
inches wide at the top of the hoop and about 12 inches tall. The down diagonal tubes are 14 inches long. As you can see it is about in the middle of your head
Fits Jeep Wrangler TJ and Rubicon 1997 - 2006.
Installation is easy. Remove the top bumper bolts, sit
the hoop on the top of the bumper and replace them. These bolts are a Torx
55 bolt head. This tool is available at any parts store. I got a Torx 55
at Autozone because of the lifetime warranty. The old bumper bolts can be tough to remove,
in some cases plan on using a big breaker bar, with a cheater pipe over the handle.
I also recommend that you get a good pair of 10,000 lbs tow hooks
(from us) and put them on at the same time. Place the hoop on top
of the factory bumper, and then the tow hooks. Then put the bolts in,
make sure to only put them in loosely and get all 4 of them started and
turned 1-3 turns before tightening any of them down. If you have bumped
or bent your bumper at all this process maybe a bit tricky. But it shouldn\'t
be any problem. I make the mounting holes in the hoop plates a bigger and oblong so it will easily fit.